GLAZING AND TESTING CAROUSEL

The Inspection and glazing carousel is made of:

• 34 metres of track on which run the trolleys supporting the frames handling the pieces;

The tracks are hold by stands and both tracks and stands are galvanized;

• 48 trolleys which are linked together to have the overhead contact line;
• 24 trolleys which have the stands to support the frames holding the piece;
• 24 trolleys have free run to make the rotation of the overhead contact line free;
• 48 trolleys are galvanized and completed with bearings and of what is necessary for the complete functioning of the overhead contact line;
• 24 rack supports in stainless steel applied on 24 trolleys holding the pieces. On each rack a mechanical rotation stop by gravity is placed to avoid their rotation during the overhead contact linerun.

The rack step is mm 1400.

The stop and go system for the rack rotation is installed inside the 3 glazing booths.

One  caterpillar specifically dimensioned and made by the kinematic chain motor// joint fluo-dynamic gearbox.

One set of stainless steel plates crankcase to protect the structure made of the stands and tracks.

Two  glazing booths (width mm 3000) with 2 rotation systems for the turnstile with manual belt.

One  fettling booth (width mm 3000).

One  washing booth with rack to clean 2 turnstile.

One  blowing piece booth.

The booths are completed by a powder sucking system with fans.

The productivity is from 2 up to 300 pieces in 8 hours, depending on the piece dimension.

The plant is completed with feeding pumps, water recycling and electrical plant.